Re: SMTA won't turn over

Posted by GordoSD on May 15, 2006 at 16:53:48 from (66.115.200.140):

In Reply to: SMTA won't turn over posted by GordoSD on May 15, 2006 at 09:36:37:

Got it running. I put a chain behind the two bolts up on the frame. Gave her a tug just to get it off a "flat spot" on either the starter or the flywheel. In 2nd gear. It was on concrete. The right wheel rolled forward and the left rolled BACKWARD. Actually spun the tire skidding to the rear.Is this normal?
But just that little movement and it fired right up.
Another question. While adjusting the carb I set it at max throttle, didn't seem very high. Turned the governor screw in a turn and a half and gained about 400 rpm...BUT then when I retarded the throttle the rpm stayed up there. I couldn't retard the throttle off that high rpm until I backed the screw out again. How do I get both the higher rpm and throttle control up there?

GW

Replies:

• Re: SMTA won't turn over Nat 2 05:17:34 05/16/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]