Re: C123 break-in procedure

Posted by Janicholson on May 25, 2006 at 13:09:12 from (199.17.6.148):

In Reply to: C123 break-in procedure posted by Jack in Ohio on May 25, 2006 at 12:30:39:

I would pre charge the oil galleries by using a pump type oilcan to inject oil into the hole for the oil pressure gauge. THis might take a quart of pumping, but it fills the system such that it is oiled immediately.
Run it at variable speeds and loads up to but not max loading for 10-15 hrs. then change the oil, and use it any way you want. After 30 hrs it will be fine to even plow or run a mill with it under load. Watch your gauges. JimN

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]