Farmall & IHC Tractors Discussion Board |
6V Charging System on 350U
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Formerly Pamike on May 27, 2006 at 08:43:30 from (4.239.165.50):
The battery went dead on our 350U over the winter. The battery shop said the battery was in a fully discharged state and questioned the charging system on the tractor. He says I need at least 7 volts at the battery to charge it. I have 8.3 out of the genny. At the voltage reg(brand new) I have about 7.3. When I get back to the battery I only have about 6.4. All terminals are very clean, and I have a 2 year old harness that runs from the genny to the reg and amp meter. The amp meter shows one needles width over onto the cahrging side, but thats all the farther the needle moves. The amp meter appears to work proprly because when I turn the key on with the engine off it goes to discharge. Is it possible that the genny just doesnt put out enough current? THanks
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|