|
Farmall Tractors Discussion Board |
Re: IH350G Utility 2 pt - 3 pt conversion
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by MrGadget on January 17, 2000 at 06:42:28 from (205.240.115.32):
In Reply to: IH350G Utility 2 pt - 3 pt conversion posted by PD2 on January 16, 2000 at 20:41:40:
I have a 350U w/fasthitch. I have two lower control arms with the ball socket the slide right into the fast hitch. No, they are not for sale, but have seen similar at TSC and Country General. Problem is...no top link mount. You can make one yourself by attaching a U-clamp to the top lift arm shaft or weld up/built a bracket that mounts into the 3 holes on the back of the rear end housing to mount the top link. As mentioned in earlier post...check out Worksaver's website. Nice line drawing of what you need. From their drawing, you can decide to build yourself, or buy from them. Since I already have lower control arms, I intend to see if they will sell me the top link bracket seperately. Just haven't gotten around to it yet.
Follow Ups:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
