|
Farmall & IHC Tractors Discussion Board |
Super C gear to drive belt pulley
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Don Mountain on May 30, 2006 at 19:23:41 from (206.72.59.151):
I have a Farmall Super C tractor that I am looking into adding a belt drive above the regular PTO shaft on the rear to drive a small hammer mill to grind corn for my wife"s chickens. I found one on ebay for sale near to me, but I wonder if the gear is already in my tractor that drives the belt drive attachment? There is just a cast iron plate above the PTO shaft now, and it is shaped like it might fit over that drive gear. Were these gears put on the drive shaft from the factory in case a dealer added the belt drive unit? Or will I probably need both? Don Mountain
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
