Farmall & IHC Tractors Discussion Board |
Re: 3 PT on S/M
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by River Bottom Farmer on June 10, 2006 at 08:58:19 from (205.188.116.133):
In Reply to: 3 PT on S/M posted by Lerm on June 10, 2006 at 08:40:31:
Lerm, I built my own three point hitch on my 39 H and I used two 2 1/2 inch cylinders on it and it will lift the front tires off the ground if I hook to something too heavy.I use a seven foot draw bar type mower that weighs in at around 1400 pounds and it lifts it easily, and it lifts everything else real easily too.I figuire you have around a 750 psi hydraulic system on the M so if your cylinder is big enough it will most likely lift it unless your hydraulics are weak.Do you use the hydraulics for anything else?Just wondering if you had a way to tell how your pump was putting out as far as pressure goes....RBF
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|