Farmall & IHC Tractors Discussion Board |
Re: Farmall BN wiring update-John T
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on June 12, 2006 at 20:50:56 from (66.244.90.5):
In Reply to: Farmall BN wiring update-John T posted by BobOHIO on June 12, 2006 at 19:38:21:
Bob, YES it matters how the ammeter is wired (its polarity sensitive) and I agree with Jim if its wired bass ackwards, it will register incorrect, but a simple wire swap will cure the problem. Regardless, ONLY one wire connects to what I call the Supply side, the hot ungrounded battery post often via the starter switch terminal, while the ammeters other Load terminal wires to the BAT terminal on a VR or Cutout Relay PLUSSSSSS feeds allllll loads like lights n ignition UNLESS one uses a 4 wire VR, in which case loads are served by the L terminal. If you turn lights or ignition on not running the ammeter (if wired correct) shoud swing to the - discharge direction. John T
Replies:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|