Farmall & IHC Tractors Discussion Board |
Super A wiring
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mark in Wa on June 15, 2006 at 22:45:29 from (207.118.68.168):
Well all is going good today. I recieved the last parts to put the Super A back together. I began assembling the new wiring harness and something didn't match up. The regulator on the tractor is mounted on top of the generator as opposed to below on the mounting bracket. This is no big deal but upon further review I realized there weren't enough terminals on the regulator. After reviewing Bob M's wiring diagrams (he really has done all of us a great service) I came to the conclusion that the regulator I have is a cut out style. It has one terminal on the outboard side labeled BAT and two on the inboard side marked GEN and F. Now to the question, Is it better to run the cut out style or a more updated regulator. What is the major difference between the two? I hate to cut the terminal end off of the wiring harness to accomodate a larger terminal end if this isn't the best set up. My second question is what would be the proper regulator to install on top of the generator and hook up as listed in the original wiring diagram. My third question is my wiring diagram lists a terminal block where the wiring comes together behind the control panel but there wasn't one there when I removed it. It looks asthough the light switch I have has a resistor on the lower side of it. Is this what is considered the terminal block? Any help would be appreciated. Thanks
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|