Farmall & IHC Tractors Discussion Board |
Re: S/N For M with HD Timing Gears
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CNKS on June 16, 2006 at 12:15:04 from (204.249.178.138):
In Reply to: S/N For M with HD Timing Gears posted by Dan Bear Kelley on June 16, 2006 at 10:48:15:
I have read on this forum that the later ones had SM gears, but my parts book does not indicate that -- no SN break. My book would have later numbers in it as it was printed in March 1960. It could be that the old gears were discontinued when the new ones came out, thus there is no need for a SN break. However the gear numbers in my book have the D suffix. Newer parts had the R suffix after 1945. Thus my conclusion (subject to correction) is that there were no SM gears in the later M's. If there were they would have been in the very late ones, shortly before the SM came out. If your M has the original engine (chassis and engine serials do not match) it makes your M about a 1950.
Replies:
Home
| Forums
Today's Featured Article -
Product Review: Kreem Brand Fuel Tank Liner - by Staff. This condition has occurred on a few machines that we have had and fortunately we were able to borrow the technique used at the local motorcycle shop. The product that we have used is called Kreem thouh there are others on the market, this one was recommended and available. This particular product is sold in three parts, a bottle of etch, dryer, and sealer. We were fortunate enough to start the process with stern warnings from those that had used this type of product before. The horror
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|