|
Farmall & IHC Tractors Discussion Board |
Questions about 560
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Carp on July 11, 2006 at 07:38:18 from (65.112.89.78):
I started tearing down my 560 diesel to replace the head gasket last night. I plan to paint is as it goes back together. I have just a few questions that you fella's can help me with. I think I can change the hydraulic filter without draining the rear end, but I am not sure. Is that correct. Can I put a turbo on the tractor without turning up the fuel? I am not looking for a big hp increase but rather a small increase and maybe a fuel effeciency improvement. I have a turbo from a Mercedes 3liter diesel that should fit like a saddle on a sow. When I put the head gasket on, what kind of gasket sealer do you guys like to use? I don't need another leaky head. I do plan to check the head to make sure it is flat before I put it back on. Thanks for the help. Carp
Replies:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
