Re: Governor and throttle

Posted by magman on July 14, 2006 at 09:09:07 from (67.142.130.41):

In Reply to: Re: Governor and throttle posted by newpuller on July 14, 2006 at 08:00:01:

No real instructions new puller, I just searched here a few weeks or so back someone told how to grind the weights and braze everything thats elogated up tight. I also have a little newer gov that was set up different that I decided to use. But the main thing was evrything tight the right spring or in my case a solid bar made on the lathe instead of a spring. and reworking the weights a little. I also redid my intakes on the head and intake with a homemade stone hone from a brake cylinder set up. Opened them up and polished them up also. The machine shop used the stock valves I did not have the intakes opened up. All ready had a new valve setand was getting pricy all ready. There are so many little tweaks but it takes time to figure them out without ruining something. the pulling board is a good place to lurk to get info and chad s has been pulling stock through stroked tractors for a loong time and sells parts also for goveners and distributors and such. I just have to be carfull that they are not monitoring RPMs with a gusge becues I have not reworked my throttle yet to go 10% over when I am checked then change it to the 2300 or more when I need it.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]