Farmall & IHC Tractors Discussion Board |
Re: Super M TA Advice
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hayfarmer on July 31, 2006 at 19:34:39 from (66.243.249.138):
In Reply to: Super M TA Advice posted by Pete_5959 on July 31, 2006 at 15:09:13:
I bought a SMTA a few years back with lots of problems. I only paid $100 for it though with aftermarket 3 point so was ok. I used it without ta on low side for a couple years then had to split it to fix the pto disconnect so fixed ta at the same time. I really like it especially with a baler. Mine only took ramp and roller setup and some seals and gaskets to repair so probably had $150 in it plus my labor. I have the blue ribbon service manuel, IT book and a parts book and used them all. Makes a nice tractor.
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|