|
Farmall & IHC Tractors Discussion Board |
B414 - converting to spin on oil filter
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by wkw on August 01, 2006 at 13:14:36 from (129.128.173.199):
I have an IH -B414 with the diesel engine and I've been researching for adapter kits to change from the cannister to a spin-on filter. I went through the Wix specialty catalogue and looked at all the adapters and phoned up the Wix technical service number. They were not of much help as they said to look at all the diagrams for the adapters and pick the right one.(I was hoping they could just tell me the right one!)
Has anyone used the Wix parts and if so can you please direct me to the correct part to order. I have attached the Wix Specialty Catalogue website address if someone can understand what is required to accomplish the conversion. Thank-you for your help.
Ken W
Drumheller, Ab
Replies:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
