|
Farmall & IHC Tractors Discussion Board |
Re: Wiring for 400
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Doc Travis on August 14, 2006 at 16:44:45 from (69.29.50.173):
In Reply to: Re: Wiring for 400 posted by arod on August 14, 2006 at 11:59:45:
The Story goes like this. I bought the tractor from this guywho knew less about tractors than I do. It had sat for a year outside and would not start. I put a new condenser, points, rotor. It Sarted ran for a while and then the wire that goes to the alt. started melting. It has just been running on the battery for a awhile. I thought about your suggestion for a bit and decided you were right but he has so many wires coming out of the dash its hard to figure it out. I am going to start from scratchon the thing so it would be nice to know what should be there and not.
Thanks Travis
Replies:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
