|
Farmall & IHC Tractors Discussion Board |
Re: One more time please! I need 2 parts and help
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Red Dave on August 31, 2006 at 09:31:43 from (24.104.94.34):
In Reply to: One more time please! I need 2 parts and help with posted by Patrick Martin on August 31, 2006 at 09:13:46:
I've rebuilt those governors, including fixing the sloppy shaft like you have. I bought several sizes of stock bronze bushings from McMaster-Carr that were close to what I needed (they don't cost much), them drilled out the casting to fit the O.D. of the bushing I used. If you aren't sure that you can do it, any decent machinist could do it for you. While you have the governor apart, it's a good time to overhaul they whole thing. A Case/IH dealer will have what you need, but you will have to piece it out, I don't think there is a kit. Any tractor salvage yard might have a new water outlet.
Replies:
Home
| Forums
Today's Featured Article -
The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
