Re: Coil wiring electronic ignition

Posted by Bob on September 09, 2006 at 23:14:04 from (66.163.134.211):

In Reply to: Re: Coil wiring electronic ignition posted by Jason Archer on September 09, 2006 at 17:57:45:

"but whats the story with the utilty that doesnt have a resister and has the negitive side of the coil going to the distributor?"

Well, if the battery (+)is connected to the chassis, the coil (+) should be connected to the distributor, no exceptions I know of.

As far as needing a ballast resistor, or not, that will depend on the coil's primary resistance, which can either be measured, or are there any part numbers on the coil we could use to figure out what coil you have?

Replies:

• Re: Coil wiring electronic ignition Jason Archer 07:41:12 09/10/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]