Farmall & IHC Tractors Discussion Board |
stepped head pistons or flat tops
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Brad in WI on September 13, 2006 at 02:38:31 from (24.208.17.95):
I have a '41 H that needs new pistons and sleeves (it is apart now). The head casting number is 8043-DC. The serial number is 58122. Can I use the stepped head piston rebuild kit from this site or not. Also it says that the valve length is 5 5/16" long but mine are about 5 3/8" long. The motor had flat top pistons in it when I purchased the tractor but it was also in a box. I had the head just cleaned up nothing extra taken off. Just want to do it right the first time. thanks
Replies:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|