Farmall & IHC Tractors Discussion Board |
Re: h not running right carb problems????
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by tim coltman on September 14, 2006 at 14:45:04 from (71.48.95.40):
In Reply to: h not running right carb problems???? posted by tim coltman on September 13, 2006 at 23:01:24:
i have already replaced the sediment bowl cleaned the tank i have good flow and that little mesh screen is no longer there because when i took the fitting out when i rebuilt the carb it came out in a couple peices. i have been messing with the float a bit because after it sits for about 10 min with the fuel on gas trickles out of the carb. i replaced the needle and seat when i rebuilt the carb because it was in the kit i bought but i think im going to put the old one back in because i cant get it to stop leaking. when i open the drain on the carb it has a good stream i let it drain into a small can for a min or two and that stayed even so i have good gas flow. tim
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|