Farmall & IHC Tractors Discussion Board |
Re: Will a 560
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on September 19, 2006 at 08:07:38 from (75.24.23.154):
In Reply to: Will a 560 posted by Narrow front fit a 856 on September 19, 2006 at 07:24:42:
The ft bolset on a 1066 with a narrow ft is compleatly differant then what is used for a wide ft. and is only used on the 66 seires . Now if ya want a narrow ft under a 06-56 then yes you can put the 560 ft post under it BUT it is lighter built . I have a 560 post under my 806 at this time since the spindels on the org. post were shot from one of the bearing locking up and spinning and i needed something to hold it up and had one jusy layen around from a 560 . I am always worried about snaping it off on a dead farrow or groundhog hole since the 806 is almost twices as heavy as a 560 and one of these days it is going to happen .
Replies:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|