Farmall & IHC Tractors Discussion Board |
Re: Man oh man.......engine block cracks........:-
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on October 15, 2006 at 04:05:33 from (216.208.58.104):
In Reply to: Re: Man oh man.......engine block cracks........:- posted by Patrick Martin on October 15, 2006 at 02:49:14:
Patrick: Please, cann the Mr. MacKay, Hugh will do just fine, bear in mind I've been called a lot worse. I've seen a lot of broken blocks in A, SA, 100 and 130. Folks used to claim you couldn't add antifreeze to the old thermosyphon A and SA without pre mixing. I guess likely they right if one only runs it 5 min, and probably not up to temp. I've added antifreeze to my SA many times, to bring it up to strength, but always when it was going to be worked for several hours. In my lifetime, I've had 3 - SA, 2 - 130 and a 140, and never had any problems. Now, I do live in a climate where your antifreeze has to test for -40F. Just maybe that keeps one a bit sharper than say for example folks that rarely see temps below 20F. I've had folks say to me, long after the first damaging frost, "Do you suppose I should check the antifreeze in that little farmall I have?" Poor time to be asking in my opinion, but you know the problem, guy who services his car or pickup, checked that. I never would have believed so many folks could be so careless about the little tractor they bought for yard work. I would almost bet money, that 95% of all C-113 and C-123 engines with cracked or repaired cracked blocks, happened as a result of freezing. They always break right behind the carburator. A few have happened as result of collision, but I'm betting the front axle will tell the tale on those, as it will be toast and block will be broken across the front.
Replies:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|