Farmall & IHC Tractors Discussion Board |
Lubricating Throw Out Bearing
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JayWalt on October 15, 2006 at 07:49:17 from (24.223.138.48):
My 300u tends to grind gears, not bnad but u gotta hold the shifter to where u feel the traqnny gears stop, then engage the gear. Before messing with the clutch pedal (since the manual is not like the actual setup at all), I'd like to lube the throwout bearing and eliminate that as an issue first. At first I thought the clutch shaft zerks were for the pilot bearing, but they are not. How do you lbe it? There is a cover under the tractor That might give me acess to it, but I dunno. Just want to make sure I do it right . Any idea would be appreciated. I wouldnt care, but because my sole use of this is the loader, there's going to be alot of shifting going on =)
Replies:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|