Farmall & IHC Tractors Discussion Board |
Re: Super A Final Drive Assembly Question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by kevinez on November 26, 2006 at 20:05:02 from (66.37.71.114):
In Reply to: Re: Super A Final Drive Assembly Question posted by banjo on November 26, 2006 at 19:14:36:
Thanks. From looking at the manual it just didn't look like that there was anything holding the lower axle shaft in. Did some looking with a flashlight up into the final drive housing. Noticed that the bolts that I used to secure the upper outside cover were too long and were binding against the large gear. Backed them out a bit and this freed it up. I guess that when I tightened the cap screw it pushed the gear enough to bind against it.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|