Farmall & IHC Tractors Discussion Board |
Re: 560 smoking
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by chadd on November 27, 2006 at 14:27:47 from (155.92.32.189):
In Reply to: 560 smoking posted by Nathan Schulz on November 27, 2006 at 13:00:25:
I think it would be pretty hard for hydraulic fluid to get into the motor on a 560. They didn't have the PESCO distributor mount pump anymore, so the only path would be to fill up the clutch housing and dump in through the rear main oil seal. I'd think by that time some other things would be noticeable. Was it smoking a dark black? If a seal went in the pump it might be possible to leak fuel into the crankcase. If it was running rich, it is possible it started running past the rings, but you don't mention any running problems, so it seems unlikely it is running that rich. Maybe someone else will have more info.
Replies:
Home
| Forums
Today's Featured Article -
Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|