Farmall & IHC Tractors Discussion Board |
Re: Ignition System Problems
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Larry Schmitendorf on November 27, 2006 at 14:50:03 from (147.182.5.50):
In Reply to: Ignition System Problems posted by Larry Schmitendorf on October 24, 2006 at 20:33:34:
Got it running. The first 2 resistors that I got were .75 oms and were only allowing about 2 volts to the coil. I replaced the resistor with a 1.85 ohm and it now starts and runs, getting about 4.75 volts to the coil. The only place that I found to get parts that was really of much help was the local NAPA store that had 2 pages of resistors to choose from that actually had the ohm ratings so I could choose what I needed. Thanks to all.
Replies:
Home
| Forums
Today's Featured Article -
Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|