Farmall & IHC Tractors Discussion Board |
Re: Which 3-point hitches will work on my M?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Rustyfarmall on December 03, 2006 at 13:30:52 from (207.32.13.209):
In Reply to: Which 3-point hitches will work on my M? posted by Blue3992 on December 03, 2006 at 11:54:59:
The M was never offered with a 2 point or 3 point hitch. A 2 point hitch would be very difficult if not impossible to adapt. 3 point aftermarket hitches are available for your M that can be attached fairly easily, and are still available brand new. I think this site may have new 3 point hitches available, and several other dealers have them also. Check out the prices on the new units before you pay too much for a pile of junk on ebay. Also, the add on 3 point hitches do not work as well as the 3 point on a tractor that was factory equipped. Depending on what the 3 point will be used for, you might be better off to trade the M for a newer tractor with a factory 3 point.
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|