|
Farmall & IHC Tractors Discussion Board |
Re: farmall M live hydraulic pump
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by 53supermwf on December 12, 2006 at 17:49:57 from (69.95.160.224):
In Reply to: farmall M live hydraulic pump posted by garry lee on December 12, 2006 at 09:05:15:
The hydraulic pump shown in the first picture I saw here is either a Behlen or an M&W. The factory IH pumps have the lines coming out of the bottom of the pump, Behlen and M&W have the lines coming out of the top.The pump from a super m should fit an m. I have a pump from a 400 on my SM as it has about 2gpm more flow capacity than my original IH pump.As for older M,s having to change the front timing cover, I have 2 sons that have a1942 and a 1944 M and both have been switched over to live hydraulics with factory IH pumps and no other changes were needed. Hope that helps
Replies:
Home
| Forums
Today's Featured Article -
The Great Escape - by Dave Hollrah. It all began Monday with a little baling of second crop on the lake shore field, and as I drove out past my sister and her hubby's place, this small calling sound could be heard from the general direction of their manure pile. Out of the yard, over the cows and bale piles, through the dozer piles, poplars, and brush, out onto the ditch grade road, past the noisy 6.2 diesel engine pulling my well traveled Suburban along. Well it sure didn't take me long to figure out what it was because I alrea
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
