Re: Finding internal engine noise.

Posted by Hugh MacKay on December 15, 2006 at 16:47:44 from (209.226.106.92):

In Reply to: Re: Finding internal engine noise. posted by P Backus on December 15, 2006 at 11:48:07:

Paul: Open shafts were a bit tricky, especially if that noise source was a U joint. It works great along the tractor castings, finding internal noise.

I basically just wanted to have a bit of fun with this. The testimonials on the YT home page made it sound as though these guys made some great new discovery. This technology has been with us since man first built machines from steel. I always like to see if I can get some unsuspecting guy to cut off his wife's broom handle without thinking about the consequences. Quite a serious buch of individuals here at YT. I figure there is no point whatever, being into old iron unless you can have some fun with the subject.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]