Farmall & IHC Tractors Discussion Board |
3 mechanical questions on a 1066
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Willy P on December 24, 2006 at 09:09:40 from (72.251.15.48):
1. I have a oil leak on the power steering cylinder on just the left side can I just replace that outside seal or do I need to take the cylinder off and put a kit in it? I am having trouble getting the pin out of the axle to get the cylinder off,maybe I can unscrew the shaft out of it and then get the cylinder out? 2. I have a leak on the bottom side of the steering motor,can I just replaace the seals on the bottom or do I need to buy the complete seal kit and change all the seals? 3. The cylinder on the clutch control rod I guess is what you call it is leaking,can I buy a kit to fix it? In my IT&T manual it doesn't say anything about it,but is it easy to fix? I am keeping the tractor not just patching it up to sell. Thanks
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|