|
Farmall & IHC Tractors Discussion Board |
686 overpriced?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mark in C.C. on December 26, 2006 at 19:30:44 from (4.158.201.150):
I called a dealer last week about a 686 he had listed in the farm paper. It is a 1980 model. He said he just put a new t.a. and clutch in it. The tires look about 75% tread left on them. The tractor has 5000 hours on it. it was inspected from grill to drawbar. nothing done to the motor. The paint shines like almost new. He said it wasn't repainted. I've just seen a picture of it so can't tell for sure. He is asking $10,900 for it. I was thinking in the $8500 range. He sounded pretty firm on his price. What do you guys think? Should I bite the bullet and pay that much or wait for him to come down or keep looking for a different one. Of course I would have to go and look at it and test drive before buying. Any and all opinions apprecaited
Replies:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
