Farmall & IHC Tractors Discussion Board |
Re: H Lift-All not lifting
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on January 02, 2007 at 15:24:15 from (66.173.50.63):
In Reply to: Re: H Lift-All not lifting posted by chad Koel on January 02, 2007 at 14:59:00:
Well that was quick, SOme of them have had their guts taken out to use the system as a resevoir. If only one hose is connected as you indicated, the system probably needs to be taken apart and diagnosed, They are simple, Review material in the archives here for belly pump removal (they are heavy and need a floor jack to handle them well) The only last gasp of possible is if the rod/lever is not attached or set to turn the control valve on the inside of the pump. It has a serrated coupling some one may have put on wrong, other than that, it means pulling it out to fix it. They are for the most part extremely fixable, and almost never fail unless run dry, or run with dirty oil. Good luck JimN
Replies:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|