Farmall & IHC Tractors Discussion Board |
Adding hydraulic output to 340U
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by PaulW_NJ on February 05, 2007 at 08:31:43 from (70.111.136.152):
My 340 Utility has two sets of hydraulic outputs on its sides that are controlled by HydroTouch valves (used for loader), and hydraulic lines running back to the Fasthitch, with it"s own TeleDepth control lever. I would like to add a set of hydraulic outputs back to the rear to attach to a hitch mounted log splitter attachment (shown in Northern Hydraulics: it comes with it"s own control valve). The 340"s external hydraulics pump is rated at 9 gpm at 1500 psi which is not terrific for a log splitter but may be sufficient. Can anyone tell me what would be involved, and where you"d tie in, to add that capability? Has anyone else tried this? Thanks Paul
Replies:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|