|
Farmall & IHC Tractors Discussion Board |
Re: Farmall Super C rear axle replacement - Help needed
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Harold Hubbard on June 29, 2007 at 20:12:48 from (66.6.176.23):
In Reply to: Farmall Super C rear axle replacement - Help needed posted by ed 342 on June 28, 2007 at 20:52:14:
You will have to remove the PTO and belt pulley to get the tubes out. One of them is the drive shaft to the PTO, the other supplies oil to the PTO unit. There is no oil pressure in it, the oil just splashes up into a channel on one side of the transmission, and drains down the tube into the
PTO. The tube is held in place by a threaded ring that you will be able to see after you remove the PTO. The ring has notches in it for a spanner, but I have always used a hammer and punch to remove them.
Replies:
Home
| Forums
Today's Featured Article -
The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
