|
Farmall & IHC Tractors Discussion Board |
Re: Farmall M clutch adjustment remaining?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ScottyHOMEy on July 05, 2007 at 12:58:10 from (71.241.200.22):
In Reply to: Farmall M clutch adjustment remaining? posted by chadd on July 05, 2007 at 11:09:18:
You're on the right track, Chadd. It's been a long time since I got into an M clutch, so I can't recall exactly how the adjustment in the linkage is set up (i.e., which way to turn the nuts), but you do use that adjustment to set up your free play. You don't do it at the fingers. You don't say whether you have the hydro reservoir on the tractor. If not, you can remove the cover plate below to see which way your adjustment is moving the throwout bearing. You might even be able to peek around the reservoir if you have one, or around the hydraulic piping where it comes out the side. I just don't remember. There may also be an access hole on the side where you can get a look in there to see which way you're going. Is the clutch slipping, or are you just trying to adjust the freeplay to specs?
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
