|
Farmall & IHC Tractors Discussion Board |
Re: horsepower of a farmall 450
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by chadd on July 14, 2007 at 16:24:40 from (4.188.135.228):
In Reply to: Re: horsepower of a farmall 450 posted by Janicholson on July 14, 2007 at 11:02:43:
Just thought that I would say that I don't necessarily agree that Torque is a Force. That is like comparing apples and oranges. A force is the mass of an object multiplied by its acceleration. It has magnitude and direction and has units of Newtons or pound force. A torque is the applied force multiplied by the perpendicular distance between where the force is applied and the center of rotation. It has units of Newton-meters or pound-feet. If there is a 10 pound force applied to a gear tooth tangent to its circular profile and the gear is 2 feet in diameter, the torque applied to that gear is 20 lb.ft.
Replies:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
