Farmall & IHC Tractors Discussion Board |
Re: 282 diesel
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Owen Aaland on July 21, 2007 at 20:04:19 from (198.70.47.171):
In Reply to: 282 diesel posted by Larry mapes on July 21, 2007 at 19:16:56:
Are you getting any smoke out of it? If you do not have smoke you are not getting any fuel delivery. Did you just replace the crank or did you have more apart? If you are sure you have all the timing marks lined up in the gear train the only other thing is the drive lug on the injection pump drive shaft. Looking at the back end of the shaft there is a dimple toward one side. There is also a matching dimple inside the pump where the shaft mates up. Both dimples must be on the same side or the pump will be 180 degress off. A lot of engines will run 180 degrees off but there ill be a lot of smoke and very little power.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|