Re: 444 international
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Casstuba on August 06, 2007 at 06:29:49 from (71.204.196.19):
In Reply to: 444 international posted by Chris Turley on August 05, 2007 at 21:15:54:
Chris,
I bought my 444 from our local dealer here in "Slower Lower Delaware" for $2700. It runs well but needs some minor repairs - small leaks, etc. the only major thing I have found is that possibly the PTO internal gears or engagement parts will need replacing.
I'm no expert, and hopefully some of the more veteran tractor guys can give you better price advice than I can. I've seen in the ads on this site and others with 444s or similar HP tractors asking between 3600 to 7000 or so in good running condition. Made me think I got a bit of a deal on mine. I'm not sure about salvage prices, but if you can't make it run before you buy it I wouldn't offer much over $1000, less if it looks like you need to put major work into it. You may be able to get a great deal on a fixer-upper.
Ask questions from whomever is selling it, about how it ran, condition of the hydraulic system, etc. I personally would pull and inspect the spark plugs, make sure that you can rotate the motor by pulling on the fan belt to make sure it is not stuck, check the condition of the tires and wheels. If it has been sitting, then you will have to change the transmission fluid and hydraulic fluids - both take Hy-Tran fluid - most likely there will be water in those fluids due to condensation not a big deal if you change the fluids. the fill plugs for those are behind the seat for the hyrdaulics, and next to the gear shift for the tranny. I'd take those off and see what you can see. Check the oil at the dipstick for antifreeze, same with the radiator for oil. Inspect the engine block for cracks or repairs - especially look around any areas that are very greasy or oily. hope this helps!
Brian
Replies:
Home
| Forums
Today's Featured Article -
Product Review: Kreem Brand Fuel Tank Liner - by Staff. This condition has occurred on a few machines that we have had and fortunately we were able to borrow the technique used at the local motorcycle shop. The product that we have used is called Kreem thouh there are others on the market, this one was recommended and available. This particular product is sold in three parts, a bottle of etch, dryer, and sealer. We were fortunate enough to start the process with stern warnings from those that had used this type of product before. The horror
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|