Posted by Bob Kerr on August 23, 2007 at 21:32:45 from (64.12.116.73):
In Reply to: Woods Mower deck 59 posted by steve Robinson on August 23, 2007 at 17:51:11:
I have an L59 deck and the bolts are left hand thread and are either 15/16 or 7/8, not sure right now. They can be a bear to take off sometimes though. Woods sells a special tool to hold the pulley still or I have used a large dia pipe smashed partly flat on the end so it slips over the end of the dull blade to hold it still. I have also used a block of wood between the blade and the deck on the front side to hold the blade still. I just tighten the bolts snug enough so the balde doesn"t slip when reattaching so it isn"t as hard to get them off the next time.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
