You are 1000% correct about only wanting about 3 to 3 1/2 gal per min to run a power steering motor. (I learned the HARD way) I busted the end off of a Char-lynn motor that was running off of an "M&W" live pump that was on the 46 H. I replaced the motor and installed a #201 pump up to the "M&W" pump and have had no problems since.
What Kirk has my dad always called a "Stand Alone" power steering setup.
I don't care for the belt driven side mounted Char-lynn pumps. I am not saying anything bad about those pumps, others use them and seem to like them a lot.
I enjoy reading your post, and have gotten a lot of good info from you by doing so. How's the Gleaner comming along?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
