Posted by a_lead on December 21, 2007 at 03:47:46 from (69.137.41.169):
In Reply to: 560 snow plow frame posted by SamC-VT on December 20, 2007 at 19:15:27:
I purchased a used Myer plow and frame from a guy last winter that was listed on this site. The plow has a wide yoke frame for the narrow front end to fit into it. The cylinder portion of the frame bolts to the front bolster on the 4 bolt holes on each side, with a support brace back to the frame rails. The hitch portion of the frame also bolts to the frame rails on the front with support arms that look like they would reach a large bolt hole in the lower area of the bell housing. I plan to modify to put on the front of my F 340 but haven"t found the time (dirtiest of all 4 letter words!!). I have a copy of the original docs. from Myer that I could try to scan & email if it would help. Edward
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
