Posted by Keith-OR on December 31, 2007 at 23:26:04 from (207.200.116.7):
In Reply to: c113 or c119 engine posted by MattMalcome1 on December 31, 2007 at 18:39:15:
I think you'll find it does have the opening for the hydraulic pump. And are you sure it is 113, most of the balers I have seen used the 123CI motor. Also it can be used on a C,A with a little modification where the notch for the starter goes. A friend just installed one on a SA, ya have to look really close to see the modification.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.