Posted by MattMalcome1 on December 31, 2007 at 18:39:15 from (207.179.198.21):
I have an old C113 engine off a baler from the 50's I think. There was antifreeze in the oil, but the engine was not run with it in there. I bought it thinking it was parts for a newer (404) international, but it is much older. As far as I know, it could easily be used for parts at the very least. What tractors will this fit? I know the block is different at the bell housing area due to a notch for the starter, but the rest should swap. It has already been fixed (did a nearly invisible job) due to a freezing block, and dosen't leak there. I have no use for in presently, but maybe a tractor could come along??? Any advice or info would be appreciated. (not a Farmall expert). Thanks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.