Posted by Farmallgray on January 20, 2008 at 18:35:10 from (96.233.247.210):
In Reply to: Serial number plate posted by Larry NCKS on January 20, 2008 at 11:15:25:
I'll do my best to answer your question. IMO the only source for correct tags is Robert Deiner (mentioned by someone else below). His are the only ones that are "relief etched". In other words, the black part is recessed below the silver part. This is the way the originals are. The other ones are a flat piece of aluminum with the black painted on. There is no texture. His are not cheap, but they cost a lot more to produce that way. I have seen a few of his samples for the F-series and they are a perfect match to the originals. He has done a lot of research to get all the minute details right and to offer all the different variations.
With all that being said, I prefer to keep the original tags if possible. But If I had to replace one, his are the only ones I would use.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
