Posted by migraine on January 25, 2008 at 08:40:55 from (67.182.151.248):
In Reply to: 240 engine swap posted by 240Utility on January 24, 2008 at 15:04:46:
The row crop block does not bolt up in the utility version. I know because I tried to tell a gent here that a block from 340 utility would not bolt up in a Farmall 404. But he thought he knew better and spent 2000 bucks redoing the 340 motor only to find out it will not bolt up. Last time I saw it the 340 motor was hanging on a stand all redone and nowhere to go with it. Plus he already threw away parts from the 404 motor so he is hexed twice. A 404 Utility or 340 Utility (INTERNATIONAL instead of Farmall) should bolt up but I would do lots of measuring before I would make the deal. Migraine
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
