When we were putting our M back together my dad took notice of how loose the oil pick-up fit the pump . He was woundering if oil presure was bleeding off due to the loose fit .
It is held in with a roll pin ! He drilled it out for the next size bigger , for a better hold .
At that point he went to the hardware store to find the correct size rubber washer to go in between the pick-up and the pump. I think he found a faucit washer that was perfect ,letting it swing free and yet sealing .
We have great oil presure, grant you the motor was fresh and the pump was rebuilt to specs.
I ran this fix past a gentelmen on Red Power with a dozer they had a oil presure problem with . They had gone as far as replacing the pump , presure relief valve the hole nine yards [ fresh motor] . He replied back about a week later laughing that a $0.30 washer fixed the problem .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
