Posted by Joe Pennington on August 16, 2008 at 12:15:25 from (68.51.24.219):
In Reply to: Fenders posted by Andy in IN on August 15, 2008 at 21:12:21:
Andy, I guess most of the farmers here in the southern part of the U.S. were just too cheap to buy a new H or M with optional fenders because I never saw a set until I traveled up into MO, IA, and IL. While fenders offer a measure of safety, they would be in the way when mounting the tractor from the front side of the rear axle. I remember when plowing small cotton and soybeans (in days before herbicides) we would often have to dismount to clean out 4 row cultivators on the two M's we used. It was quicker to step straight down to cultivator from front of axle (would have been a pain with fenders). Rember cultivators would plug up with vines and grass especially when using the cultivator "fenders" which allowed a faster cutivating speed and helped keep from covering up the small cotton and soybean plants. Just what I remember from the fuzzy past. Joe P.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.