Posted by spiffy1 on December 28, 2008 at 06:29:22 from (70.41.137.72):
Thought I'd be at this point a couple months ago; and I also thought I knew how to make these come out, but I was wrong on both! :oops:
Anyway, I have both ends bare except the bearing retainers (and the bolts are out). I sprayed both retainer with PBlaster, tapped the front retainer with a punch, turned it (pressed to the bearing, it turns in the block) and tapped it a few times hoping to loosen things a bit, then put a 2X4 in front of the crank and whacked it good a few times.... nothing.
Next step, I'm thinking flywheel puller over the front [I think it will fit the bolts in the front retainer], tighten it up and whack it good. However, before I apply that kind of force, Did I miss a step? Can the cast handle that? Any other tips?
Also, I noticed some random pin head size pitting in a few spots on the crank. It's been quite a few years since I've had to polish up a crank, but IIRC a few times around with a strip of crocus cloth (until there are no "convex" imperfections) and the babbit never knows the difference.
Gettting lots of pictures again, most uploaded to the computer, but still haven't gotten around to uploading any for posting. There's always tomorrow! :wink:
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.