I have one for a 200 series (two point hitch). My dad had one for his A. My Uncle had one that mounted on a C or SC. All were two disk units. The first short comming was that they did not cut as wide as two 14 bottoms. When my father bought the land in 1948 most of it was in forest. He cleared the land and as you can imagine there were many roots and stumps. The disk tended to cut through the roots better than the plow. After about two years he traded the A for a C with two 14 mounted plows. We never looked back. My Uncle gave up the twin disk plow for two 14's in the late 1950's. Understand that our land was sandy. In the north part of the state where clay is dominant, all plows are disk. Most farmers used a chisel plow followed by a disk harrow or just the harrow alone. The disk plow I have came from a farmer in the piedmont where soils are high in clay content.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
