Posted by rustyfarmall on May 18, 2009 at 05:34:04 from (209.152.78.140):
In Reply to: Plowing with a H? posted by Spook on May 17, 2009 at 18:01:53:
Spook said: (quoted from post at 18:01:53 05/17/09) I have a 48 H with a Saginaw 3 pt hitch, I also have a 3pt 2 bottom plow. I am thinking of plowing with it, but I am worried about the hitch being attached to the rear axle castings, not the drawbar. Is using a 3 pt plow a good idea?
The ORIGINAL horseshoe drawbar for the H also attaches to the axle housings. IH intended for the pull type plow to be hitched directly to that horseshoe drawbar. The SWINGING drawbar was an optional, extra cost accessory, and was never intended to be used with a plow.
So to answer your question, using the 3 point to pull a plow will not be any different than using the standard, horseshoe drawbar.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
