I been traveling n missed the VR discussion below but until Bob arrives I have some thoughts. I"ve come across what I believe were suppression diodes on some units which is one of the reasons they would be polarity senstive.... One thing to consider when trying to dampen and supress arcing across VR relay contacts is that its not quite as simple as that relay just opens n closes similar to the old manual Low High charge light switches, they can "chatter" which acts to me like pulse width modualtion for more precise regulation and that amounts to changing the frequency (duty cycle) so Im not quite sure selecting the capacitance n resistance values will be as easy as if it were straight DC On and Off switching. Of course, each is still a single discrete DC switching occurence so maybe it IS EASY AFTER ALL????
The coatings on those relay contacts is expensive and Id tend to contribute that fact to why they may be scripming to save a few bucks and why the new ones fail so soon?????
Any agreement or disagreement or thoughts ?? NO WARRANTY ON THIS LOL just brainstorming here
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
