Posted by Grademan on June 28, 2009 at 12:31:36 from (71.12.0.190):
I have a 49 model M Farmall that idled rough and smoked a little before a complete rebuild. I went back with aluminum pistons that are oversized by using thinner sleeves, valve job, bearings etc.. When I got it back togther the smoking was gone but it still ran rough at idle, so I sent the carb to Denny's Carb Shop for a rebuild. Put it back on and it still idles rough. It runs perfect under load with lots of power but does not idle correctly. What is wrong with this tractor? Could it be a governor problem as I have not messed with it?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.